Tower Beacon Indicators Series TA

Where would I use tower indicator beacon?

Manufacturing Machines, Packaging Machines, Shops, Offices, etc...

What would I use them for?

Typically where a number of status signals are required simultaneously. e.g. 'Machine Shutdown', 'Power ON', 'Require Assistance', 'Material LOW', etc...

Why use a tower beacon?

Tower beacons are more convenient when more than one beacon indicator is required - Single fixing point. Individual indicators do not obscure one another.

You have strobe versions and non-flashing lamps. What about flashing lamps?

A Static (non-flashing) tower beacon may be used as a flashing device in one of two ways:-

1. The easiest way is to provide a pulsed signal directly from the control source (e.g. PLC)
2. We manufacture a solid state flasher module which is ideal for use with our tower beacons. One of these modules is sufficient for flashing a 1 - 5 module tower. Selection of which modules are to flash and which are to remain static is achieved at installation.

	D.G. Controls Limited Cadley Hill Road Swadlincote Derbyshire DE11 9TB ENGLAND Tel: +44 (0) 1283 550850 Fax: +44 (0) 1283 550776 Click HERE to contact us
www.beaconlamps.com "The Leading-Light in Warning Beacons" Celebrating 13 years online - 1995 to 2008!
Terms and Conditions of Sale | Legal Notices Copyright © Reserved Whilst every effort has been made to ensure the accuracy of this information, we operate a policy of continuous improvement, and reserve the right to alter models and specifications without notice.  All values and specifications are nominal rather than exact, and where applicable, are with the rated supply voltage only, using new lamps and components.  All information is given in good faith but without guarantee to performance figures.  Where shown all dimensions are in mm unless specifically indicated otherwise.  E&OE

01/01/08